![]() The fan curves types are linear, graph, target, mix, sync, and flat. The first one is based on linear function, the second on a custom curve, the third is based on a temp that holds the speed until a target temperature is met, the fourth allows you to use two different curves and apply a mix function (max, sum), and fifth syncs to an existing control, while the last allows you to set a fixed percentage value. It allows you to save, edit, and load multiple profiles at once, and it's capable of reading the temperature from multiple sources such as the CPU, GPU, motherboard, hard drivers, and the ".sensor" file. For example, you can create custom external temperature sensors using the said ".sensor" file. However, the app's main purpose is to provide you with as much control as possible in order to keep your workstation at an optimal temperature. Thus, you can fine-tune the fan control response with steps, activation percentage, and response times, and hysteresis. The app also has a somewhat simple graph fan curve editor. It allows you to add, remove, and drag points around the graph. You are receiving this because you were mentioned.Of course, you can also copy and paste points from a graph to another, as well as fine-tune the response with the hysteresis and response time parameters. Then watch your fans IRL as you slide each to figure out which is which. Just assign a curve to the appropriate control, it should work. On Jun 3, 2022, at 12:41 PM, Rem0o wrote:īut you mentioned the fans stopped during detection right? Don't bother with the speed cards with RPM, or any of the "detected" stuff from the assisted setup. You are receiving this because you were mentioned.Message ID: from my iPhone If you can see your fans changing speed, then you're all good. ![]() On Jun 3, 2022, at 7:20 AM, Rem0o That's because since you got multiple fans on the same channel, the RPM detection is bust, so it can't rely on it. You are receiving this because you authored the thread.Message ID: from my iPhone Reply to this email directly, view it on GitHub, or unsubscribe. And is the Mobo Controller set to the Right DC or PWM Control on SYS_Fan 1 corresponding to your Fans Ans what Connection do ther Use 3 Pin DC Control or 4 Pin Pwm Control. ![]() ![]() On Jun 3, 2022, at 7:13 AM, Audipower wrote:Ĭan you Control this Fans with the Mobo Settings in Bios ? Some Case fans are 1 Speed Only. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |